Black spar change kit for fins:- Application:change your own spars and give your fins a second life – Resistant to marine atmospheres.
Stéphane DUDON´s advice:- Remove your old spars and scrape the palm to make the remaining glue traces disappear.
– Install the needle on the Denty Spearfishing glue tube reference:CCL5GR Apply the glue to the 15 cm from the end of the wing:- Apply the directional end spar.
Flip the wing apart from the lip and re-apply the glue Hold for a minimum of 2 minutes – Apply the glue the entire length of the sail about 50cm Apply the fine spar.
Flip the wing apart from the lip and re-apply the glue – Hold for a minimum of 2 minutes – Wipe away traces of glue overflowing on the wing.
– A few hours later traces of cyanolite may appear on the wing.
You can easily clean them with water and dishwashing liquid with a sponge.
– Be careful not to put glue on your fingers.
To do this use gloves.
Carefully follow the instructions for the use of the glue as well as the technical and safety sheets.
100% Made in EUROPE.
Reviews
There are no reviews yet.